EAP 683 UR showing Rx dropped packets and Rx error on LAN
I have deployed 4 EAP683 UR in an office environment and have noticed that all the APs report Rx dropped packets and sometimes Rx errors on LAN.
Only 5Ghz channel is enabled on all APs as 2.4Ghz creates too much interference, so it has been disabled on all APs.
All the APs uplink is wired with Cat6 running at 2.5Gb full duplex and Mesh is disabled.
Flow control is enabled at router and switch ports.
Unscheduled Automatic Power Save Delivery and OFDMA is set to ON on all APs.
Network setup is as follows:
Router - ER8411 v1.0,
Controller - OC300 v1.0 (with Controller Version 5.14.26.23)
Switch - TL-SG3210XHP-M2 v1.0
APs - EAP683 UR V1.0
All firmware is up-to-date.
Any tips or suggestions is welcome.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
i have the same problem.
last week i installed my new network at home.
TL OC200
TL ER707-M2
TL-SG2008P
TL-SG2008P
TL-EAP683 UR
TL-EAP655
The EAP683 UR showing RX dropped packets. With a ration of 35% but when i change with the EAP655 its almost 0%
what is the solution?
- Copy Link
- Report Inappropriate Content
The RX dropped packets calculation mechanism of EAP683 UR is more comprehensive. Do you have any wireless issues? If not, you may ignore that.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 920
Replies: 22
Voters 0
No one has voted for it yet.