@Clive_A 

 

Thanks

 

Updated, havent seen any problems yet.  My OC200 immediately saw it and readopted / configured.  No looping.  All 3 WANs work, all 8 LANs work, all ACLs seem to be working.

  @Clive_A 

 

I have had to go back to 1.2.1 official

 

I was getting no internet connectivity on 3 of my 8 vlans randomly for reasons I cannot determine.  With absolutely no config changes and back on 1.2.1, no issues whatsoever

  @GRL 

 

hmm, that was weird. I haven't noticed any problems. but i only have 5 vlan. Did you reboot the router and switches after the upgrade? I have seen that it can solve strange things?

 

  @MR.S 

 

yes, several times, and on a schedule too

 

Nothing in any logs indicate anything going awry when a vlan loses internet connectivity.  DHCP is still serving IP addresses, DNS addresses and the gateway just fine.  Just that end devices cant go out to the internet.  Internal routing (such as access a printer on another VLAN using ACLs) worked fine though.

 

the moment i reflashed 1.2.1 and rebooted, all was well.

  @GRL 

 

ok, yes there is a lot that can happen with firmware so it is good that they have started with this Early access program so that we can find the errors as before the definitive release. As I said, I haven't noticed anything here with me yet.

 

 

Hello everybody! I need some help with my OpenVPN client at ER8411 router. The tunnel is already setupped and working fine but I can’t route any traffic to this tunnel.. (( There is NO interface available for OpenVPN client connection. May be I need to setup this interface manually? Can anybody help me? I’ve tried the last beta fw update but it does not support interface for OpenVPN like older versions. (( Best regards.

  @avpopov1977 

 

it doesn't work well when you don't get traffic through the tunnel.  I don't know which interface you are talking about either. there is not much to configure on OpenVPN, if you are thinking of a LAN interface, you set it here.

 

 

 

in stand alone you set it here, here you can only use one network.

 

Thank you for the fast reply!

 

  @MR.S 

 

 

Here what I wrought about! Developers just forgot to add OpenVPN interface here.... 

Also OpenVPN interface not available for Policy_Routing... ((

 

Best Regards!

  @avpopov1977 

 

not sure what you are doing over there in the static route.

 

i think you are going too deep down the rabbit hole. Just follow the guide. Most important thing is to have your OpenVPN on a different subnet. So if everything is 192.168.1.0 etc, your OpenVPN needs to be something different than anything else 192.168.20.0 etc. getting it to work is easy if you follow the guide. You can complicate it by setting different acls and vlans after. More complicated is attempting to get anything over 250-300mbs throughput.