Business Community > WiFi > EAP235 downlink port without vlan dont work
< WiFi

EAP235 downlink port without vlan dont work

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP235 downlink port without vlan dont work

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP235 downlink port without vlan dont work
EAP235 downlink port without vlan dont work
2024-07-12 22:53:25 - last edited 2024-07-16 11:22:28
Model: EAP235-Wall  
Hardware Version: V1
Firmware Version: 3.1.1
Hi. I have a managed EAP235-Wall with Omada Version 5.8.36. I have tried to activate the ETH1, ETH2 and ETH3 ports but I have not been able to pass traffic because it activates them with vlan and I do not have a managed switch. I did the test by placing an administered swicth and creating the vlan2 and the result was satisfactory. Is it possible to activate ports without a vlan?
File:
EAP235.pngDownload
  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:EAP235 downlink port without vlan dont work-Solution
2024-07-15 11:18:20 - last edited 2024-07-16 11:22:28

  @JavierHernandez 

Why did you add VLAN to it? By default, the ETH port can function. So, don't enable the VLAN and leave it alone.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
4 Reply
Re:EAP235 downlink port without vlan dont work-Solution
2024-07-15 11:18:20 - last edited 2024-07-16 11:22:28

  @JavierHernandez 

Why did you add VLAN to it? By default, the ETH port can function. So, don't enable the VLAN and leave it alone.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
Re:EAP235 downlink port without vlan dont work
2024-07-15 17:16:48

  @Hank21

 

When tried to enable without vlan show me in red.

 

 

Will be error from my controller?

  0  
  0  
#5
Options
Re:EAP235 downlink port without vlan dont work
2024-07-15 18:51:17

  @JavierHernandez 

As Hank said, don't tick any of those boxes unless you actually want tagging to occur.  Otherwise, they all simply act as a L2 switch attached to the uplink port of the AP.

<< Boycotting this site and these products until CANADIAN firmwares get some love >>
  0  
  0  
#6
Options
Re:EAP235 downlink port without vlan dont work
2024-07-16 11:21:41

  @JavierHernandez 

You should un-check ETH Port Settings.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#7
Options

Information

Helpful: 0

Views: 427

Replies: 4

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.