Radar detected on channels 36 and 48

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Radar detected on channels 36 and 48

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

timdj

2024-07-12 09:59:58 - last edited 2024-07-17 09:39:12

Posts: 2

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2024-07-12

Radar detected on channels 36 and 48

2024-07-12 09:59:58 - last edited 2024-07-17 09:39:12

Model: EAP650

Hardware Version: V1

Firmware Version: 1.0.15

I've am struggling with DFS. I get radar detected and it after a while it will change the channels to a non-DFS channel which is completely congested and unusable and I have to manually change this back every time.

I was looking into the logs and noticed that radar detection is also active on the lower channels. I'm not sure if any action follows out of this but I did find it peculiar.

1 Accepted Solution

Hank21

2024-07-16 06:38:34 - last edited 2024-07-17 09:39:12

Posts: 3673

Helpful: 724

Solutions: 497

Stories: 8

Registered: 2021-12-13

Re:Radar detected on channels 36 and 48-Solution

2024-07-16 06:38:34 - last edited 2024-07-17 09:39:12

@timdj

This is the design. Once the AP detects radar on the DFS channel, it switches to a non-DFS channel. You can only reboot it or wait 30 minutes before manually changing the channel.The radar detected on channels 36 and 48 may be due to your bandwidth settings of 160Mhz. If the radar is detected on channel 52-64 (DFS channel), the radar on the main channels 36 or 48 that you designated will be displayed in the log.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

Radar detected on channels 36 and 48

Radar detected on channels 36 and 48

Information

Voters 0

Tags