Prevent AP from connecting to other AP (mesh)
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi, I would like to know if there is a settings to prevent access point in Omada from connecting via other AP as mesh.
I have this setup.
Room A with Switch A and Access Point A
Room B with Switch B and Access Point B - switch connected to Room A Switch A
this 2 rooms are not that far but have 2 walls and around 7 meters in gap.
Typically i have an AP that is connected via poe switch, when doing a maintenance in Room A i unplug the room B switch uplink, after this i noticed that the switch B is still connected to the controller and checked it was connected still in Switch A but different port which is the port where the AP A is connected, there is no mesh icon in AP B but i assumed this what happened. When i plug the uplink back it lights up and then off.
What i did is just replug the power in switch b and it all work accordingly.
Still, is there any settings to disable any AP to connect via mesh and set their uplink priority via wired?
Thank you all.
