Business Community > Controllers > Omada OC200 device compatibility
< Controllers

Omada OC200 device compatibility

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Omada OC200 device compatibility

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Omada OC200 device compatibility
Omada OC200 device compatibility
2024-06-22 03:34:26
Model: Omada Cloud-Based Controller  
Hardware Version: V2
Firmware Version:

I am going to upgrade my network for security and VLAN creation

 

the hardware I currently have is as follows

 

TP-Link Archer AX55 / AX3000 4-Stream Wi-Fi 6 Router


TP-Link-SG108PE Smart Switch


TP-Link AP WA 901ND Access Point

 

I intend to replace the AX55 with  an ER605 V2 Omada Gigabit VPN Router and an OC200 Omada Cloud Controller

 

I want to know if my smart switch and AP will work with the new configuration

 

  1      
 
  1      
 
#1
Options
4 Reply
Re:Omada OC200 device compatibility
2024-06-22 03:46:53
TP-Link AP WA 901ND this is not omada access point
  0  
  0  
#2
Options
Re:Omada OC200 device compatibility
2024-06-24 06:44:33 - last edited 2024-06-24 06:52:00

  @corkscrew22 

It should be noted that the smart switch TL-SG108PE and the AP TL-WA901ND are incompatible with the Omada controller. They cannot be managed by the controller, thus you have to set up them independently. They can work together to meet your needs.This article describes how to configure VLAN for easy smart switches:How to configure 802.1Q VLAN on TP-Link Easy Smart

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#3
Options
Re:Omada OC200 device compatibility
2024-06-24 11:19:53

  @Hank21 

so with the new router ,and controller , the controller can only config the router and and any omada AP i add to the network.

 

where im a little confused if i manually setr up vlans in the smart switch then i configure the router to talk to these using the controller is that correct?

 

  0  
  0  
#4
Options
Re:Omada OC200 device compatibility
2024-06-25 02:22:21

  @corkscrew22 

Yes, even if you set up the switch independently, it will still work with the new router and the APs managed by the controller. And, if you configure vlans properly, they can communicate with one another.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#5
Options

Information

Helpful: 1

Views: 700

Replies: 4

Related Articles
Migration from Cloud Controller to OC200
326 0
problem in adding a device
696 0
URL Filtering for Specific Device Only
172 0
 Router Compatibility Omada OC200
1503 0
 Omada Web Controller displays the wrong device in the Known Clients list when you click on it?
366 0
Oc200 V1 compatibility
409 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.