Can't make VLAN Configuration as desired
Hello, all.
Please, can someone help me to configure my TL-SG108 as following:
1. Ports 1,2,3,4 as VLAN1
2. Ports 1,5,6,7,8 as VLAN2
Obviously traffic between VLANs is isolated except the port 1 which needs to talk to both VLANs.
I tried in simple port VLANs, but couldn't leave port 1 in VLAN1 and VLAN2 simultaneously.
I tried in 802.1Q:
- Add Port 1 to VLAN 1 as an untagged member.
- Create VLAN 10: ports 1, 2, 3, and 4 are untagged members.
- Create VLAN 20: ports 1, 5, 6, 7, and 8 are untagged members.
- PVID Settings: set PVID of Ports 1, 2, 3, and 4 to 10; set PVID of Ports 5, 6, 7, and 8 to 20.
Doesn't work - port 1 is unable to talk to VLAN2.
I assigned PVID10 to port 1 - the same result.
Many other combinations tries - something does not work always.
I will be very thankfull for the advice on the required configuration.
Best Regards
Hi @PLeon
Thanks for posting in our business forum.
Don't be this. I am not trying to be mean but I am not impressed by how you express your self-centered opinion.
First, let me confirm again, if you are talking about the access between VLAN(802.1Q), that's not possible. It is the essence of the VLAN and it is developed based on the RFC. Or are you referring to something else? Please give me a bigger picture than your original post.
And, I am not you and I don't understand what you mean by "my old TP-LINK did this". What kind of setup was it?
Second, if the first is what you need, and it is not possible, there is no need to persuade me to configure something impossible to do for you. I have given you the instructions on how VLAN works. If you won't listen, I am okay with that.
If you just need a guide, go back to the switch page, and look at the pinned thread, if you just need "how can I implement what I need".
