Wireguard configured on VLAN instead of a lossless subnet

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Wireguard configured on VLAN instead of a lossless subnet

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Wireguard configured on VLAN instead of a lossless subnet
Wireguard configured on VLAN instead of a lossless subnet
2024-03-13 23:50:22
Tags: #VPN
Hardware Version: V5
Firmware Version: 5.13.23

Hi,

 

I was wondering if it is possible to configure wireguard for a VLAN instead of a lossless subnet. The question is because i would like to configure application blocks, which is only possible (AFAIK ) with VLANS, not with subnets.

 

Many thanks for the response!

 

Kind regards, 

  0      
  0      
#1
Options
1 Reply
Re:Wireguard configured on VLAN instead of a lossless subnet
2024-03-14 07:14:32

  @Naldjer 

At present, it is not possible to assign a VLAN for WireGuard VPN. However, you can assign a VLAN to a subnet.

 

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options