Router is steadily reconfigured after enabling WAN2
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
we're currently running the latest Omada-version (5.13.30.10) on an OC200-controller v1.0. Since we aquired a second modem, we wanted to use the second wan port of the tl-er7206.
As soon as we enable the setting in the omada controller, the router reboots as expected and comes up as normal. But then, the controller keeps on cyling "configuring, connected, ping lost". And in the "result of application" the status keeps on "applying".
The logs do show an issue on the omada controller side.
Can you please fix it, as soon as possible?
Kind regards,
Lars Kusch
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
we found time yesterday and have fist tried to only unplug all wan connections -> without sucess.
Then we reset the device - now it could successfully apply the configuration.
Thanks for your help!
Very much appreciated.
- Copy Link
- Report Inappropriate Content
Hi @LarsK1
Thanks for posting in our business forum.
How many devices do you have? The sync speed varies when you have either too many config on the router or too many devices in your network.
Have some patience and wait for it to finish its application.
- Copy Link
- Report Inappropriate Content
@Clive_A thanks for your fast reply.
The controller controls 1xSwitch, 2xAPs and this router.
We waited for at least 1 hour. The router was initially connected after 5 minutes and then began again, and again, and again. Therefore the connection to the Internet keeps on disconnecting.
- Copy Link
- Report Inappropriate Content
Hi @LarsK1
Thanks for posting in our business forum.
Have you ruled out the WAN duplicated IP?
Just enable WAN 2 and don't connect anything, will it be synced quickly?
- Copy Link
- Report Inappropriate Content
just tried, unfortunately still the same.
- Copy Link
- Report Inappropriate Content
Hi @LarsK1
Thanks for posting in our business forum.
LarsK1 wrote
just tried, unfortunately still the same.
Back up your current config now for later use.
Disable that port and enable it again, will it recover? Or reset the router. Don't reset your controller.
Lastly, try this firmware if you will.
https://community.tp-link.com/en/business/forum/topic/649884
- Copy Link
- Report Inappropriate Content
I will try. Will report back
- Copy Link
- Report Inappropriate Content
we found time yesterday and have fist tried to only unplug all wan connections -> without sucess.
Then we reset the device - now it could successfully apply the configuration.
Thanks for your help!
Very much appreciated.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 484
Replies: 7
Voters 0
No one has voted for it yet.