OC200 and ER605 when I try to adopt controller changing IP of router
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi All
I have
When I try adopting EAP225 and EAP115 I have no longer access to internet via Wi-Fi also when I try adopt the router, controller changing IP of router and I'm unable to login to router and failing to adopt the router at the end... after that I need to reset router to factory settings and setup router again.
Can someone help please.. Not sure what I'm doing wrong.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Did you pre-configure it? Set an ip address in the wired network for testing, this IP will be the router's IP.
- Copy Link
- Report Inappropriate Content
Hi Virgo
Thanks for reply..
Yes I set-up static IP on each device
ER605 192.168.1.10 gateway 192.168.0.1
Switch 192.168.1.50
EAP_1 192.168.1.51
Eap_2 192.168.1.52
Also on controller 192.168.1.55
- Copy Link
- Report Inappropriate Content
You need to set all your information up in the Controller first, before adopting anything, otherwise the Controller pushes it's default info overwriting whatever was in the devices beforehand, which makes the new default LAN 192.168.0.1/24. Based on the info provided above, results in the same subnet being on the WAN and LAN sides of your ER605. This is the same problem that @VasquezPL is currently trying to fix in a similar thread here https://community.tp-link.com/en/business/forum/topic/653988 (where I provided some controller screen grabs to help illustrate what needs to be in place prior to adopting the devices)
- Copy Link
- Report Inappropriate Content
@d0ugmac1 Thanks for link... Looks promising... When I get time I will try setup controller
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 606
Replies: 4
Voters 0
No one has voted for it yet.