Business Community > Pharos Wireless Bridges > Set Point to Point
< Pharos Wireless Bridges

Set Point to Point

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Set Point to Point

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Set Point to Point
Set Point to Point
2024-01-25 14:22:05 - last edited 2024-01-26 06:30:54
Model: CPE220  
Hardware Version: V3
Firmware Version: 2.2.2 Build 20200612 Rel. 51711 (0000)

How to configuration CPE220 with long distance (850m)

  0      
 
  0      
 
#1
Options
2 Reply
Re:Set Point to Point
2024-01-26 06:31:32

  @Joentaks 

 

indecision If you do a search on this forum, you'll also see the answer to your question all over the place. 

https://community.tp-link.com/en/business/forum/2?page=1

Just striving to develop myself while helping others.
  0  
  0  
#2
Options
Re:Set Point to Point
2024-02-12 12:27:21

To configure the CPE220 for long-distance (850m), you'll want to ensure proper alignment and settings. Start by adjusting the antenna alignment for optimal signal strength. Then, adjust the transmission NSFAS power and channel settings to maximize performance over the distance.

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 338

Replies: 2

Related Articles
 Point to Point Wifi
1196 0
Outdoor Access Point Set-up
294 0
 Access Point
840 0
 CPE210 point to point set up question
2754 0
Access Point not detected
563 0
 CPE 220: Covering 13km radius with point to point wifi
1353 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.