No connection to wireless network when linking to VLAN
Hello,
As mentioned I am running the 3-in-1 ER7212PC v.1.0, firmware 1.1.1 and the EAP613 v.1.0, firmware 1.4.3.
I have set up two LAN's (as interfaces) on VLAN 1 and 40. I have also set up two WIFI's which I would like ot link to said VLAN's. When I enable VLAN on the WIFI setup and point to either 1 or 40, I am no longer able to log into the WIFI. If I disable VLAN, I can log in just fine.
What might I be doing wrong...?
Thank you!
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @3660
Thanks for posting in our business forum.
Instead of using the ACL, it introduces the config steps.
- Copy Link
- Report Inappropriate Content
@Clive_A Tank you for your input ;o)
However, it does not work... I still get the same result.
- Setting up LAN - Check
- Setting up ACL - Check
- Setting up WLAN (without VLAN) - Check when logging in from wifi device
- Enable VLAN on WLAN - No longer able to connect from wifi device
- Copy Link
- Report Inappropriate Content
Hi @3660
Thanks for posting in our business forum.
3660 wrote
@Clive_A Tank you for your input ;o)
However, it does not work... I still get the same result.
- Setting up LAN - Check
- Setting up ACL - Check
- Setting up WLAN (without VLAN) - Check when logging in from wifi device
- Enable VLAN on WLAN - No longer able to connect from wifi device
It's been a week now. And there isn't any new information that is helpful to me to check. Can you draw a diagram and paste your screenshots for an illustration of your issue?
Would be great to get your screenshots checked and your issue reproduction by ping tests.
If you are unsure about the ping test, please read the KB.
- Copy Link
- Report Inappropriate Content
Setting up like so:
Logging into Kids wifi and testing:
Adding VLAN:
Now I can no longer log into Kids wifi.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi @3660
3660 wrote
Think about why I did not reply to you. These are not helpful until this rely. I clearly and politely asked you for a diagram. That would be the key I need to tell if you have set it up or not.
You did not tell me where the EAP is connected.
Now, you are telling me port 5 is the EAP, is that correct?
Remove the PVID.
Please follow the guide on the official website. FAQ. Don't try anything you don't know and have the skill to fix.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 3217
Replies: 9
Voters 0
No one has voted for it yet.