Change ER605v2 Omada Controller IP to Another IP without Resetting it.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have several remote ER605 v2 routers pointed to my Omada Controller using a static public IP.
I have to get a new ISP so I will need to change the static public IP of the Omada Controller.
Is there a way to change the IP that the router has set for the Omada Controller without resetting the TP-Link if it is already managed by a controller?
Thanks,
I think the easiest/safest way is to do a controller migration, ie spin up a new controller, migrate the config, then migrate the devices. It won't be seamless, but the interruption should be in the order of a few outages of a few minutes each as devices get reprovisioned in their new virtual home.
Have a look here (image below is from p.13) as that's how you 'change' the controller from an IP to a URL remotely:
https://static.tp-link.com/2019/201910/20191023/managing_the_omada_controller.pdf?configurationId=18625
I think the easiest/safest way is to do a controller migration, ie spin up a new controller, migrate the config, then migrate the devices. It won't be seamless, but the interruption should be in the order of a few outages of a few minutes each as devices get reprovisioned in their new virtual home.
Have a look here (image below is from p.13) as that's how you 'change' the controller from an IP to a URL remotely:
https://static.tp-link.com/2019/201910/20191023/managing_the_omada_controller.pdf?configurationId=18625