5.13 Controller not showing ER605v1 ports?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Noticed that graphing detail was missing today. Should I not be able to tell which port the 2nd and 3rd items are connected to? I suspect they may be the same device (my Pi clone running the latest controller), but I would like to see the port it is attached to.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @d0ugmac1,
After confirming with the engineer, it doesn't support showing the Omada Gateway's LAN port numbers, and thanks for your valuable feedback, I've recorded this request and will report it to the developer team for evaluation.
- Copy Link
- Report Inappropriate Content
Hi @d0ugmac1,
Thank you so much for taking the time to report the issue to our community!
May I know whether this issue occurred after the controller firmware was upgraded?
Can you be sure which device is connecting the router's ports?
What is the firmware version of ER605 V1? Can a reboot fix it?
- Copy Link
- Report Inappropriate Content
Sorry Hank, I might be chasing ghosts. It looks like only the router WAN and all switch ports get labelled. No router/gateway LAN ports are labelled...is this by design?
- Copy Link
- Report Inappropriate Content
Hi @d0ugmac1,
After confirming with the engineer, it doesn't support showing the Omada Gateway's LAN port numbers, and thanks for your valuable feedback, I've recorded this request and will report it to the developer team for evaluation.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 371
Replies: 3
Voters 0
No one has voted for it yet.