EAP245: Differences between standalone devices and 5-units pack devices
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
Lately I bought a couple 5-units EAP245 packs and some standalone EAP245 units.
1. While I expected a PoE injector to be missing in the 5-units pack, I was very surprised to observe unadvertised differences between the two types of AP:
- standalone units have hardware version 4 and support 1.2.1 firmware
- pack units have hardware version 5 and support 5.0.7 firmware
Is it expected ?
2. Looking at a 5-units pack device through a 5.12.9 controller, how can I enable ETH2 PoE ? With standalone units, you can use Config/Advanced panel to enable ETH2 PoE but this entry is missing for 5-units pack devices.
Cheers
Hello @Oliv2831，
Please check the Specifications of 5-units pack, there is no POE injector contains in the package.
As for the difference of the hardware and firmware version, it depends on local sales strategies and local retailers.
On the controller, click on the radio in the device list within the Omada controller, go to Config > Advance > and its below.
Hello @Oliv2831，
Please check the Specifications of 5-units pack, there is no POE injector contains in the package.
As for the difference of the hardware and firmware version, it depends on local sales strategies and local retailers.
On the controller, click on the radio in the device list within the Omada controller, go to Config > Advance > and its below.