Business Community > Requests & Suggestions > interface speed option, change hw address
< Requests & Suggestions
 
0
Votes

interface speed option, change hw address

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
 
0
Votes

interface speed option, change hw address

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
interface speed option, change hw address
interface speed option, change hw address
2023-11-16 01:56:32 - last edited 2023-11-23 07:19:03
Model: EAP690E HD  
Hardware Version: V1
Firmware Version: 1.01

option to select interface speed and duplex,

option to change hw address especially for wireless part , this is for privacy reasons, and maybe some people don't want users to know who made their access point, this should require Allow Data Collection on

 is possible to decrease the power below the 7dbm minimum ?

factory default shouldn't be on full power on wireless, who wants more power can change the settings.

 

#1
Options
2 Reply
Re:interface speed option, change hw address
2023-11-17 03:30:34 - last edited 2023-11-17 03:31:41

  @grigore_2023 

 

It's usually done by forcing the port rate of the router/switch connected to the front end of the EAP to change interface speed and duplex what you're talking about. And the tx power is limited by local laws and regulations.

Just striving to develop myself while helping others.
#2
Options
Re:interface speed option, change hw address
2023-11-23 07:23:48

  @Virgo 

the interface speed option should exist , the transmission power is defined only as maximum power not as minimum, you should be able to set as minimum as you need.

#3
Options

Information

Helpful: 0

Views: 260

Replies: 2

Voters 0

No one has voted for it yet.

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.