ER7212PC and "Lock to AP"
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
hello. my ER7212PC router doesn't seem to have "Lock to AP" feature. my access points are EAP650's. the user manual for the router does show that feature. but the browser controller doesn't seem to have it.
firmware for the router and AP's are up to date.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @chans
Thanks for posting in our business forum.
Lock to AP is not available on the controller of ER7212PC. It was introduced in V5.9.9 while the ER7212PC V1.1.1 adapts to V5.8.
You might need to wait for the next release of the 7212PC.
- Copy Link
- Report Inappropriate Content
Hi @chans
Thanks for posting in our business forum.
Lock to AP is not available on the controller of ER7212PC. It was introduced in V5.9.9 while the ER7212PC V1.1.1 adapts to V5.8.
You might need to wait for the next release of the 7212PC.
- Copy Link
- Report Inappropriate Content
thanks, Clive.
do you mean new version of the hardware? or firmware? if the former, then i'm out of luck, unless i purchase another router?
- Copy Link
- Report Inappropriate Content
Hi @chans
Thanks for posting in our business forum.
chans wrote
thanks, Clive.
do you mean new version of the hardware? or firmware? if the former, then i'm out of luck, unless i purchase another router?
No. The firmware. Because the ER7212PC is a 3-in-1 device. Every firmware it gets will have a controller version. You can check the release note and see more details about it. Each release note will mark its built-in Controller version.
- Copy Link
- Report Inappropriate Content
ok. thanks
will look forward to new firmware
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 574
Replies: 4
Voters 0
No one has voted for it yet.