BUG: ER605 with L2 VPN and Tools?
Hi all, was helping a forum member with their setup over the weekend when I discovered an unusual flaw. We have two sites, A-B connected by L2TP/IPsec VPN tunnel in network extension mode with ER605v2 at either end. Only the LAN (default) subnet from each site is forwarded across the tunnel and what I noticed was that even with the tunnel setup and working properly I could not use the new Tools function to ping across tunnel, ie using A-ER605 to ping B-ER605 didn't work. A traceroute showed iA-ER605 trying to go direct to the internet, instead of via the tunnel. If I used a local Tools-supported switch, then A-Switch could ping B-ER605 and all devices at the B end correctly via the tunnel. I feel this is a bug, but curious if others have seen this.
A second issue with this sort of tunnel creation is that the remote subnet routes don't show up in the Routing Table insight which also seems wrong (although functionally it's fine).