No device reachabe after ACL
Hello and sorry for disturbing again.
I feel a bit stupid right know that I have that many problems. But it's the first time that I try to configure a network with omada.
I now have the following problem.
I created a network with the components:
OC200
ER7206
SG2218P
SG3428
3x EAP615
After everything was working, I created a management VLAN like in the WIKI described and added every device to it. The IPs were correct (only the gateway was still showing the 192.168.0.* IP) and everything was manageable via the OC200.
I was not able to bring attach the gateway to the management VLAN.
After all those configuration I wanted to deny the inter VLAN communication (strange that its allowed by default) by adding an ACL.
Here I obviously did a mistake. I created one switch rule were I denied communication between any network and vice versa.
Know nothing is visible anymore from the OC200.
Will this rule also block intra VLAN traffic?
How can I reverse this setting? Will a device reboot reset the last non saved settings? Like it is with Cisco for example (running and saved config)
Hope for your help.
BR
Sebastian