Cpe510 update firmware from 2.2.0 to 3.2
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Cpe510 update firmware from 2.2.0 to 3.2
I purchased two Cpe510s for point to point use and in both the firmware version is indicated: v2.2.2 Built 20201111 Rel 58267 (4555). I downloaded the firmware v3.2 from tp-link site. The downloaded file is: CPE510(UN&US&EU&ES)_3.0_2.2.4_Build20230616.zip I unzipped it and inside there was a BIN type file: CPE510(UN)_3.20-up-ver2-2-4-P1[20230616-rel32656].bin date: 28 Jube 2023 size: 5697 kb I tried to upload, but the upload never finishes. After an hour I stopped it but the original software had not been changed. What should I do to update the firmware?
1 Accepted Solution
Re:Cpe510 update firmware from 2.2.0 to 3.2
Hello @umbertosantulli,
May I know the hardware version of you CPE510? You can find it on the labels or check it on the management page. The firmware you downloaded need to correspond to the hardware version.
Best Regards!
>> Omada EAP Firmware Trial Available Here <<
>> Get the Latest Omada SDN Controller Releases Here <<
*Try filtering posts on each forum by Label of [Early Access]*
Re:Cpe510 update firmware from 2.2.0 to 3.2
Thanks to the availability. I attach the labels of CPE510. Version V3.2 is indicated.. On the Pharos System page , the firmware version is indicated as V 2.2
File:
Re:Cpe510 update firmware from 2.2.0 to 3.2
And this is the internal system page
File: