My LG TV drops the connection with my EAP653 for no apparent reason
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
My TV stream PLEX content fine but after a while drops the connection for no apparent reason from the EAP. Is there a way I can troubleshoot or access a LOG on the EAP about this issue. My phone also stopped loading at the same time and I think dropped the connection.
EAP is connected with cat6 to the POE switch TL-SG2210MP.
I also Have a ER605 v2 is there a way to see how many ISP reconnection I made through the day? I want to be able to see if my WAN connection drops!
This is my Radio status right now.
Should I change my channel width to 40 and check again?
Hey @Hank21 all my problems were fixed after I turn the hotspots to auto and then run the AI optimizations at night. For some reason after 2 days both hotspots were on the same channels on 2.4 instead of each a sepperate one but after setting them to auto and running the AI wifi they are never sharing a channel anymore. so its all good. I dont know why they were not on sepperate channels for the first 2 times the AI run but now its fixed.
Both EAP 653 v1 are in the latest stable version. my layout goes as follows
I think I found my problems but im answering anyway . All the APs where set by default in the channel 1 and the autoselection fo channels was off. Is that a known default behavior of the omada APs in general ? The picture is taken AFTER fixing the APs radio settings
Hello @Xarishark,
How many EAPs do you have?
You may try using the AI WLAN Optimization feature to improve your network performance, check here：
AI WLAN Optimization helps improve the wireless network performance. With the AI WLAN Optimization feature, the controller will detect WiFi interference and monitor the wireless environment. Based on the environmental factors including network topology, deployment size, traffic, and client factors, the controller can determine the optimum wireless configurations (such as channel, bandwidth, power, etc.) for the access points (APs), and thus ensures that wireless clients of each AP can enjoy better WiFi experience.
Hey @Hank21 all my problems were fixed after I turn the hotspots to auto and then run the AI optimizations at night. For some reason after 2 days both hotspots were on the same channels on 2.4 instead of each a sepperate one but after setting them to auto and running the AI wifi they are never sharing a channel anymore. so its all good. I dont know why they were not on sepperate channels for the first 2 times the AI run but now its fixed.
Both EAP 653 v1 are in the latest stable version. my layout goes as follows