EAP650-Wall downlink port specification

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP650-Wall downlink port specification

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP650-Wall downlink port specification
EAP650-Wall downlink port specification
2023-09-05 11:19:40 - last edited 2023-09-07 05:50:51

Hi

 

I would like to find out some specifications about the EAP650-Wall downlink port. I can't find anything about that port in the general manual for access points ("Omada Access Points_User Guide(EU&US") on the support page.

 

  1. Can the port be disabled?
  2. Can I enable VLAN for the port? In that case, what type of VLAN functions are available? MAC VLAN?
  3. Is it a PoE port?

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:EAP650-Wall downlink port specification-Solution
2023-09-06 06:27:47 - last edited 2023-09-07 05:50:51

  @PederAlm 

 

1. No, you can not disable the port.

2. Yes, you can set the PVID for the ETH port.

3. I'm afraid it doesn't support, you should see these"One port supports PoE OUT. The PoE OUT feature requires 802.3at PoE+ input and the maximum output is 13 W." if it supports, but it hasn't on the spec.

Just striving to develop myself while helping others.
Recommended Solution
  1  
  1  
#2
Options
3 Reply
Re:EAP650-Wall downlink port specification-Solution
2023-09-06 06:27:47 - last edited 2023-09-07 05:50:51

  @PederAlm 

 

1. No, you can not disable the port.

2. Yes, you can set the PVID for the ETH port.

3. I'm afraid it doesn't support, you should see these"One port supports PoE OUT. The PoE OUT feature requires 802.3at PoE+ input and the maximum output is 13 W." if it supports, but it hasn't on the spec.

Just striving to develop myself while helping others.
Recommended Solution
  1  
  1  
#2
Options
Re:EAP650-Wall downlink port specification
2023-09-06 09:20:46
Okey so I need the EAP655-Wall to get the PoE downlink. In addition to the EAP650-Wall specifications on the website, where can I read about the PVID support for the downlink? Where did you get that information?
  0  
  0  
#3
Options
Re:EAP650-Wall downlink port specification
2023-09-07 02:59:31

  @PederAlm 

 

I just searched it from my memory, I can't show my settings screenshot to you because I am outside now, but you can find it in Controller UG.

 

Just striving to develop myself while helping others.
  1  
  1  
#4
Options