accessing RX TX speeds via home assistant

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

accessing RX TX speeds via home assistant

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
accessing RX TX speeds via home assistant
accessing RX TX speeds via home assistant
2023-09-01 14:35:57 - last edited 2023-11-30 08:32:49
Model: CPE510  
Hardware Version: V3
Firmware Version:

I would like to report transmit and receive rate data to my Home Assistant, usually these things are done with a scrape but the antenna management page is a bit complex and the data does not seem to be visible. Do you have any suggestions on how I might attempt to access this data? Thank you.

  0      
  0      
#1
Options
1 Accepted Solution
Re:accessing RX TX speeds via home assistant-Solution
2023-09-04 06:52:34 - last edited 2023-11-30 08:32:49

  @Gianlucaf 

 

There is the Monitor on the cpe interface, can you see it?

 

Just striving to develop myself while helping others.
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:accessing RX TX speeds via home assistant-Solution
2023-09-04 06:52:34 - last edited 2023-11-30 08:32:49

  @Gianlucaf 

 

There is the Monitor on the cpe interface, can you see it?

 

Just striving to develop myself while helping others.
Recommended Solution
  0  
  0  
#2
Options