Home

Forums

Stories

Knowledge Base

Business Community > Controllers > Device management function

< Controllers

Device management function

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Device management function

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

MR.S

2023-08-04 09:06:45

Posts: 2259

Helpful: 807

Solutions: 290

Stories: 0

Registered: 2018-08-17

Device management function

2023-08-04 09:06:45

Model: Omada Software Controller (Windows)

Hardware Version: V5

Firmware Version: 5.12

@Clive_A

I have a question about device management function, I have tested but im not sure this work,

is this same function as unifi have? they cal it inform host.

is there requier new firmware on device to get it to work?

Unifi controller

5 Reply

Hank21

2023-08-09 07:39:38

Posts: 3673

Helpful: 719

Solutions: 497

Stories: 8

Registered: 2021-12-13

Re:Device management function

2023-08-09 07:39:38

Hello @MR.S ,

It is used to achieve L3 Management, you can put the Controller WAN IP/Hostname into this field.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

MR.S

LV5

2023-08-09 07:54:38

Posts: 2259

Helpful: 807

Solutions: 290

Stories: 0

Registered: 2018-08-17

Re:Device management function

2023-08-09 07:54:38

@Hank21

Yes, I see, but that didn't really answer my question. let's say I adopt an EAP653 for example to the controller on the same lan as the controller, then I move the EAP653 to a remote LAN, the EAP653 does not connect to the controller again so nothing is saved in the device. I either have to use the discovery tool or option 138 gets the EAP653 to connect to the controller again.
So what exactly is this function for?