Omada mesh / roaming with two EAP670 possible without Omada Router/Switch ?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Omada mesh / roaming with two EAP670 possible without Omada Router/Switch ?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Omada mesh / roaming with two EAP670 possible without Omada Router/Switch ?
Omada mesh / roaming with two EAP670 possible without Omada Router/Switch ?
2023-07-28 06:37:38

Hi,
is it possible to use two eap670 attached to another router/switch not coming from TP-LInk / Omada  with a software controller and mesh and fast roaming / ai roaming still work or is mesh / fast roaming / ai roaming and so on only possibe with a tpl link omada router/switch? 

  0      
  0      
#1
Options
1 Reply
Re:Omada mesh / roaming with two EAP670 possible without Omada Router/Switch ?
2023-07-28 15:10:12

  @Daniel2908 

 

Possible, but not a good configuration....  If you adopt BOTH APs to the controller, configure it, and launch AP2 at Site B.  Then L3 Adopt it to Site A.  It will work.  

 

You could just configure both sites separately.... and create the same SSID at both sites.  Matters on signal strength, the wireless clients will roam between sites due to the signal strength.  

 

 

I can not teach anyone anything - I can only make them think - Socrates
  0  
  0  
#2
Options