readopt devices after pc crash

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

readopt devices after pc crash

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
readopt devices after pc crash
readopt devices after pc crash
2023-07-04 15:33:21
Model: EAP225  
Hardware Version: V3
Firmware Version: V5

Hi all,

 

i used the software controller on my old pc to controll the accespoints.

but due to a crash i installed the controller on an other pc and i'm not able to get the devices adoped to the new pc(controller)

 

i even tried 2 different pc's,

    pc 1 does not detect any AP

    pc 2 does detect the AP's but is not able to adopt them.

 

i already tried factory resetting the AP's but this also did not work.

also did a firmware update of the AP

 

greetings Wouter

  0      
  0      
#1
Options
2 Reply
Re:readopt devices after pc crash
2023-07-05 05:44:38

  @vaneerwo 

 

Check if the AP gets a valid IP, and try to ping it. This may help you:

What should I do when the Omada Controller (V4) fails to adopt the devices?

Just striving to develop myself while helping others.
  0  
  0  
#2
Options
Re:readopt devices after pc crash
2023-07-05 12:39:17

  @vaneerwo 

 

If you didn't have a backup of your controller, or at the very least the Device user/password established by the old Controller, then you will need to start again from the beginning.

 

My guess is that PC1 has a Windows Firewall or something going on that is blocking the discovery process.

<< Paying it forward, one juicy problem at a time... >>
  2  
  2  
#3
Options