Best Settings for EAP225 in residential application
Hello everyone.
Until now my EAP225s have worked flawlessly. This past week my home was part of the large Summit outages. Since then I am encountering speed issues.
My current system is as follows.
I have a 2 floor home, each floor has a ceiling mounted EAP225. Both have (2) SSIDs. (1) at 2.4Ghz and (1) at 5Ghz. Those names are matched on both floors.
I have the 2.4ghz set to channels to help with the traffic from neighbors Wifi, and my 5G network is set to auto.
Hardwired I am always in the 500 up and down range at the lowest but average about 800 on a 1G service.
Since the outage my speed has improved at my hardwired station but at most I get 75 on 2.4 and 400 on 5g.
Is there any recommendations anyone could share?
2.4GHZ setup
Channel Width
20/40Mhz
Tx Power
High
5Ghz
Channel Width
20/40/80Mhz
Tx power
High