ER605v1 Beta 1.2.3 not able to configure 1:1 NAT on Linux Controller 5.9
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
@Fae Note sure if it is because it's beta-ware, but the "One-to-One NAT" tab isn't showing up in my controller.
This was clearly listed as Feature #11 in the beta release notes.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @d0ugmac1,
A new 1.3.0 Official firmware has been released, please follow the post link below for details.
ER605 V1_1.3.0 Official Firmware (Released on May 17th, 2023)
The missing One-to-One NAT issue has been fixed in this official firmware, you may take your time to upgrade the 1.3.0 firmware and confirm the issue you encountered has been resolved.
- Copy Link
- Report Inappropriate Content
Hello @d0ugmac1
Thank you for your valuable feedback. It has been reported to the developer team for confirmation. The missing One-to-One NAT issue will be fixed in the upcoming official firmware.
- Copy Link
- Report Inappropriate Content
Hi @d0ugmac1,
A new 1.3.0 Official firmware has been released, please follow the post link below for details.
ER605 V1_1.3.0 Official Firmware (Released on May 17th, 2023)
The missing One-to-One NAT issue has been fixed in this official firmware, you may take your time to upgrade the 1.3.0 firmware and confirm the issue you encountered has been resolved.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 498
Replies: 2
Voters 0
No one has voted for it yet.