@d0ugmac1 

my nas (192.168.0.101)(software controller in a docker container) is conected to the lan side of my er605v1 

there shouldnt be any vlans 

and to clarify its "adopt-looping" on its own 

d0ugmac1 wrote

  @rausimous 

 

Until recently I was running that exact config (ie ER605v1 and SC5.8.4), and it ran fine for many months.

 

I suspect you have a weird configuration error which is isolating the ER605 from the controller once adopted...forcing it to reboot, re-adopt etc etc.

 

Have changed any of the default management settings? 

Is the port the controller connects to VLAN'd?

Have you statically configured any IP addresses or VLANs?

 

  @rausimous 

upgrading to the beta has not  fixed the isue 

 im going to replace the v1 with a newer v2 

the v1 is going back to the store that sold it in 2 weeks (20/4/2023) 

current state : 

with the beta it adopts  (i think it also did this without the beta) 

then it drops the wan interface (same as before) 

then it tries adopting again and fails to repond to the adopt comands (same as before) 

tldr; beta hasent changed a ting for my problem 

  @d0ugmac1 

i think i mapped all the ports to the host  so there shoulnt be any isues ?? 

i added 27002 tcp to the list (controller searching port) maybe thats my isue 

 

  @rausimous 

update  opend up port 27002 

then i get the normal stuff 

factory reset

adoption pending

adoption failed (becous of a wrong login) 

input right credentials 

adopting 

the normal stuff like configuring ....

provisioning 

conected 

then wan goes down 

hardbeat missed 

adopting

and the cycle of adoption starts 




i have now tryed with and withouth seting it up before provisioning 
 

  @rausimous 

My er605 v2 also started to adopt loop 

I figured out that my isp router was giving out ip adres in subnet 192.168.1.xxx

And giving 192.168.2.1 as gateway 

Via dhcp 

192.168.2.1 doesn't exist in my network 

So basically if your wan interface is setup wrong then your router will adopt-loop ?? 

I will test my v1 with beta software in a few hrs 

  @rausimous 

Ive been battling the same issues with my er605v2, stuck in the same adopt loop, it doesnt seem to affect the network as Im not dropping packets or anything. However it does spam my phone with notifications that the router has disconnected/reconnected etc

Troubleshooting Ive completed so far

Rolled back OC300 to 1.13.1 firmware - no change
Rolled back er605v2 to 2.0.1 - no change

Im going to firmware upgrade the ER605v2 to the latest firmware that just came out a few days ago and see if issue changes. Also Im going to spin up a software controller on my server to see if i can isolate issue to either the er605 or the OC300. Worst case both are under warranty