@xxxaidi 

Could you tell us what you are trying to accomplish on the ACL and perhaps put a few screenshots on here?   Is the switch managed (by a controller) or standalone?

It could be a number of reasons for the ACL not working

  @Philbert Hi,

So the switch is standalone and not being managed by a controller. The setup is basic and I have been trying to figure out whether the switch would support L2 ACLs which are port ACLs meaning that interface is not a L3 routed port and I have assigned a static IP on default VLAN. Just wondering if perhaps its a config issue or ACLs on L2 interfaces are not supported altogether.

  @xxxaidi I think you should check to see if you've put in the right firmware version. You might also try to reset your device to factory settings and then set up the ACLs again. If you still can't figure out how to set it up, call the support team so they can assist you figure out what's wrong.