Home

Forums

Stories

Knowledge Base

Business Community > Routers > ER8411 - Can't change RJ45 ports 4 through 11 after being joined to Controller

< Routers

ER8411 - Can't change RJ45 ports 4 through 11 after being joined to Controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ER8411 - Can't change RJ45 ports 4 through 11 after being joined to Controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TimD553

2023-02-25 00:42:56

Posts: 3

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2020-11-09

ER8411 - Can't change RJ45 ports 4 through 11 after being joined to Controller

2023-02-25 00:42:56

Tags: #VLAN & Multi-Networks #WAN Setup

Model: ER8411

Hardware Version: V1

Firmware Version: 1.0.2

Basically what the title says - after joining the ER8411 to a Controller you can't change the RJ45 ports (#4 - #11) from WAN to general LAN ports. I've read that this is possible prior to joining a Controller but I haven't tested this yet.

Is this a known issue?

https://www.reddit.com/r/TPLink_Omada/comments/10q7pjx/fyi_er8411_router_unable_to_change_lan_port/

1 Reply

Hank21

2023-03-03 08:26:06

Posts: 3673

Helpful: 718

Solutions: 497

Stories: 8

Registered: 2021-12-13

Re:ER8411 - Can't change RJ45 ports 4 through 11 after being joined to Controller

2023-03-03 08:26:06

Hello @TimD553，

TimD553 wrote

Basically what the title says - after joining the ER8411 to a Controller you can't change the RJ45 ports (#4 - #11) from WAN to general LAN ports. I've read that this is possible prior to joining a Controller but I haven't tested this yet.

The port 4 is WAN port and the RJ45 ports (#5 - #11) is LAN port by default, could you tell us more details about the question?

Do you see any error message?

Do you mean you can not set the PVID or change the port link speed for ER8411 in controller mode?

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*

ER8411 - Can't change RJ45 ports 4 through 11 after being joined to Controller

ER8411 - Can't change RJ45 ports 4 through 11 after being joined to Controller

Information

Voters 1

Tags