Guest Portal not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Guest Portal not working

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Guest Portal not working
Guest Portal not working
2023-01-29 16:44:09
Hardware Version:
Firmware Version: 5.8.4

Hi Support,

 

Iam trying to get the following working but am not sure if this is possible with the TP-Link Omada Controller.

 

We have Omada Controller hosted on a Windows server 2022 in our Datacenter. The access points are located in the remotes sites connected through DMVPN to the Omada Controller. Access points are connected and working as it should except the Guest SSID when using a Portal. Without a portal clients are able to connect and send traffic.

 

Clients that are connected to the Guest network only has internet access thus wireless clients wont be able to reach the Wireless controller since guest traffic is not routed over the DMVPN tunnel. Even though the Omada Controller has internet access the guest portal is not able to be presented to the wireless guest clients. This I think is probably the reason why it is not working.

 

So now how to get this working without routing the guest network over the DMVPN tunnel to towards the corporate network? Is this even posible?

 

Hope to hear from you.

 

Thanks!

Arpanet

 

 

  0      
  0      
#1
Options
2 Reply
Re:Guest Portal not working
2023-01-31 07:04:58

  @Arpanet69 

 

The Client require to communicate with the Controller to make the portal work.

 

That's an old problem and people are voting for the feedback&request post. Let's vote here

 

 

 

  0  
  0  
#2
Options
Re:Guest Portal not working
2023-02-02 19:37:31

  @Somnus 

 

Well another posibility is to create a route to the host (omada) over the dmvpn and just allow 80 and 443. But this means it will need a unique subnet per spoke location.

  0  
  0  
#3
Options