Home

Forums

Stories

Knowledge Base

Business Community > Switches > TL-SG2008P receiving two IP addresses from Firewalla Gold

< Switches

TL-SG2008P receiving two IP addresses from Firewalla Gold

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-SG2008P receiving two IP addresses from Firewalla Gold

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

ASN45

2023-01-29 14:41:39 - last edited 2023-02-03 21:04:20

Posts: 4

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-02-22

TL-SG2008P receiving two IP addresses from Firewalla Gold

2023-01-29 14:41:39 - last edited 2023-02-03 21:04:20

Model: SG2008P

Hardware Version: V3

Firmware Version: 3.0.4 Build 20221130 Rel.42340

Hello,

I have a TL-SG2008P JetStream switch that is receiving/pulling two IP addresses. One is 10.0.1.60, which is correct as shown on the controller management interface for the LAN network in which it is plugged into via Ethernet. The other IP address is a VLAN I have setup for an EAP610 mesh AP (WiFi). My Firewalla Gold router is showing the IP address as 192.168.44.58 (VLAN). Can someone explain this behavior and how I can fix it to only use 10.0.1.60?

1 Accepted Solution

Somnus

LV5

2023-01-31 06:50:13 - last edited 2023-02-03 21:04:20

Posts: 1212

Helpful: 219

Solutions: 72

Stories: 0

Registered: 2021-06-14

Re:TL-SG2008P receiving two IP addresses from Firewalla Gold-Solution

2023-01-31 06:50:13 - last edited 2023-02-03 21:04:20

@ASN45

You must created VLAN interfaces for the switch.

I'm using 3 VLANs and so the switch has 3 IP in different VLANs. But if you want you can disable it.

TL-SG2008P receiving two IP addresses from Firewalla Gold

TL-SG2008P receiving two IP addresses from Firewalla Gold

Information

Voters 0

Tags