NVR keeps rebooting after displaying the cameras on screen

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

2022-12-08 06:26:38 - last edited 2024-09-19 08:04:16

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-12-08

NVR keeps rebooting after displaying the cameras on screen

2022-12-08 06:26:38 - last edited 2024-09-19 08:04:16

Model: VIGI NVR1016H

Hardware Version:

Firmware Version:

Hi there, nvr can assign itself an IP address or Auto and connect itself to the internet then able to display the cameras on screen

after a minute the nvr reboots. The cable is attached to the 16 port POE tplink switch TLSG1218MP i made an update of nvr firmware

tne it still re boots. this re booting does not happen and able to display the cameras in stand alone mode

I would tp link technical people or any one who has the same experience

any solution thnks

1 Reply

LV2

2023-01-10 00:00:57 - last edited 2024-09-19 08:04:06

Posts: 82

Helpful: 15

Solutions: 3

Stories: 0

Registered: 2022-01-15

Re:NVR keeps rebooting after displaying the cameras on screen

2023-01-10 00:00:57 - last edited 2024-09-19 08:04:06

I also got a big problem after the mentioned above update.

NVR was in a sort of boot loop, every time it had network connection to the cameras.

After I unpluged network cable, I was able to go into settings and remove all the cameras. After that, NVR also worked with network connected.

As soon as I connected to 1 camera (3rd party, ANPVIZ with 5MP, Dome) NVR gone crazy again.

So, I downgraded it to 1.0.1 again, but this should not be the solution.