Business Community > Routers > 3 WAN backup
< Routers

3 WAN backup

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

3 WAN backup

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
3 WAN backup
3 WAN backup
2022-12-05 20:25:58
Model: TL-R470T+  
Hardware Version: V6
Firmware Version: 6.0.4 Build 20200313 Rel.32850

Hello

I'm trying to configure setup with 3 WAN ports, and want them to be prioritized by the order.

So everything should work through one port, and if it goes down - switch to the next one and so on,

but if previous port is back up - switch back to it.

It works fine for two WANs, since they are defined as "primary" and "backup" ("secondary") in the rule, but there is no "tertiary" 🤷‍♂️

Any ideas how to achieve this ?

  0      
 
  0      
 
#1
Options
6 Reply
Re:3 WAN backup
2022-12-06 08:23:27

  @chuq 

May be you can set 2 Primary WAN and 1 Backup WAN, check Failover(Enable backup link when any primary WAN fails). in Mode.Hope that helps:)

  0  
  0  
#2
Options
Re:3 WAN backup
2022-12-06 12:07:43 - last edited 2022-12-06 12:08:22

@gatewait 

But how to prioritize these two primary WANs in this case ? Which one will be actually used ?

  0  
  0  
#3
Options
Re:3 WAN backup
2022-12-07 01:07:47 - last edited 2022-12-07 02:10:08

chuq wrote

@gatewait 

But how to prioritize these two primary WANs in this case ? Which one will be actually used ?

Hi chuq,if Load Balance is enabled, traffic will also go first to the first WAN. Or you can set a Policy Routing rule to let traffic go to the first WAN you set up. 

And sorry for my mistake, Check Failover (Enable backup link when all primary WANs fail).

  1  
  1  
#4
Options
Re:3 WAN backup
2022-12-12 10:21:44 - last edited 2022-12-12 10:22:47

Seems like two primary wan setup doesn't work. I mean it works while both wans are online, but if one of them goes down - you gets random clients without internet

  0  
  0  
#6
Options
Re:3 WAN backup
2022-12-13 00:44:35

  @chuq 

Have you try to set a Policy Routing rule to let all the traffic go through the first wan?

It's strange that it won't work when one wan down.

  1  
  1  
#7
Options
Re:3 WAN backup
2023-01-05 22:03:02

  @gatewait Policy routing seems to be ignored. I can't get all traffic to go through primary WAN. I have load balancing disabled and it still uses the secondary WAN/LAN1.

  0  
  0  
#8
Options

Information

Helpful: 0

Views: 1025

Replies: 6

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.