3 WAN backup
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello
I'm trying to configure setup with 3 WAN ports, and want them to be prioritized by the order.
So everything should work through one port, and if it goes down - switch to the next one and so on,
but if previous port is back up - switch back to it.
It works fine for two WANs, since they are defined as "primary" and "backup" ("secondary") in the rule, but there is no "tertiary" 🤷♂️
Any ideas how to achieve this ?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
May be you can set 2 Primary WAN and 1 Backup WAN, check Failover(Enable backup link when any primary WAN fails). in Mode.Hope that helps:)
- Copy Link
- Report Inappropriate Content
But how to prioritize these two primary WANs in this case ? Which one will be actually used ?
- Copy Link
- Report Inappropriate Content
chuq wrote
But how to prioritize these two primary WANs in this case ? Which one will be actually used ?
Hi chuq,if Load Balance is enabled, traffic will also go first to the first WAN. Or you can set a Policy Routing rule to let traffic go to the first WAN you set up.
And sorry for my mistake, Check Failover (Enable backup link when all primary WANs fail).
- Copy Link
- Report Inappropriate Content
Seems like two primary wan setup doesn't work. I mean it works while both wans are online, but if one of them goes down - you gets random clients without internet
- Copy Link
- Report Inappropriate Content
Have you try to set a Policy Routing rule to let all the traffic go through the first wan?
It's strange that it won't work when one wan down.
- Copy Link
- Report Inappropriate Content
@gatewait Policy routing seems to be ignored. I can't get all traffic to go through primary WAN. I have load balancing disabled and it still uses the secondary WAN/LAN1.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 787
Replies: 6
Voters 0
No one has voted for it yet.