EAP615-Wall does not power a C400HP cam
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I have a EAP615-Wall connected to and powered by a SG2210MP.
I want to connect and power a VIGI C400HP camera to the EAP615-Wall.
The EAP615 can provide 12W and the C400HP only uses max 3W, so I expected the EAP615 could power the camera over its PoE out port.
But this does not work. The camera does not power up. Why not? Are there PoE settings?
Extra info:
• The SG2210MP has more than enough power left.
• The EAP615 works fine.
• The C400HP camera (connected with PoE directly to the SG2210MP) works fine.
• I tested the setup also with short cables nearby the switch, but the camera does not power up.
• When I use the 12V adapter of the camera, everything works fine (with the camera connected to the EAP615).
@RickJamesBish Yes, that's it. Thanks, it now works like a charm. If you know the setting does exists you can look for it.
The ETH Port Settings of the device are under the device "Config" tab in the "Advanced" section. (The 2.4 / 5 GHz tabs in the top gave me the impression that the whole section was about wireless.)
Added a screenshot for anyone else overlooking the setting...
@RickJamesBish Yes, that's it. Thanks, it now works like a charm. If you know the setting does exists you can look for it.
The ETH Port Settings of the device are under the device "Config" tab in the "Advanced" section. (The 2.4 / 5 GHz tabs in the top gave me the impression that the whole section was about wireless.)
Added a screenshot for anyone else overlooking the setting...