RE: AP MODE MAX DISTANCE
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
Setting up a P2MP network using WBS510 + TL-ANT5819MS with connecting clients CPE510 and CPE610/710.
Would like to know the max distance in AP mode. Did some searching with no luck. Maybe someone here has answers.
The base station is only visible to about 20-30 meters!
Faulty antenna or base station? or both?
TIA
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Could be settings issue, what Transmit power did you choose?
It can be found on the WBS510 Wireles settings page.
- Copy Link
- Report Inappropriate Content
transmit power is set to maximum. put up a cpe510 on the same pole a feet below and was able to connect a cpe610 at 1.16km away with no issues.
something is definitely wrong with WBS510 + TL-ANT-5819MS. its transmitting like a home router only visible to a few meters
who or what could be causing this issue?
TP-LINK support is unreliable
- Copy Link
- Report Inappropriate Content
Maybe the antenna is not installed correctly? Try unplugging the TL-ANT-5819MS and checking if there is any difference on the SSID signal. Perhaps the antenna is just not taking effect.
- Copy Link
- Report Inappropriate Content
I'm a bit bothered when you said that the antena is not yet taking effect. It's strange to comprehend from a product that you expect to work right out of the box. I made sure that the connections are tight as it is not easy bringing down a 20foot pole on top a 130 foot hill. I also took the average calculation of the down tilt to ensure that the clients can achieve at least 95% visibility on the base station.
TP-LINK support is still struggling to comprehend the situation.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 377
Replies: 4
Voters 0
No one has voted for it yet.