TL-SG105PE - No HTTPS protocol available to login.
TL-SG105PE - No HTTPS protocol available to login.
Dear all,
I bought 3 TL-SG105PE switches because they are manageable.
I tried to access them with the https protocol with no luck.
Only http is accepted by the switches and this is unacceptable: the user and passwords are sent in clear text over the network, it's very dangerous.
The bad thing is that I didn't find any option to enable (and force) the https protocol.
Could you please tell me how to enable it?
I searched the forum but what i found is a message without any answer and this is a bit scary....
https://community.tp-link.com/en/business/forum/topic/503876
Thanks
Regards
Daniele
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Yes, I was looking at this Tl-SG2210MP because the other model has only 61W over 8 POE port, but it cost about 190 euros....
https://www.tp-link.com/it/compare/?type=smb&typeId=5748&productIds=43626%2C41002
I will think about it.
We are here to learn from our mistakes. Lesson learned!
Thanks again.
Regards.
Daniele
- Copy Link
- Report Inappropriate Content
No worries.. if you need anything else just ask and will try and get back to you as soon as free
In terms of Wattage for POE.. 60w is a reasonable amount, most APs only pull around 5-7watts on average, cameras around the same. For example my own switch has 3x APs (EAP245s), 1x controller (OC200) and 2x Ring Camera running off it at present and its totalling around 33watts.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1769
Replies: 12
Voters 0
No one has voted for it yet.