OC200 & EAP225 10mbps Max on Wifi

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

OC200 & EAP225 10mbps Max on Wifi

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
OC200 & EAP225 10mbps Max on Wifi
OC200 & EAP225 10mbps Max on Wifi
2022-09-13 13:14:12
Model: EAP245  
Hardware Version: V3
Firmware Version: 5.0.9

We have a 50mbps internet connection but when i connect to any of the Four EAP225 access points i cannot get above 10mbps up or down. There is no bandwidth configured in the OC200 and i have tested the POE Switches by plugging into them and running a speed test its getting close 48mbps. I have replaced patch cables between the router and poe switch but no change.

  0      
  0      
#1
Options
3 Reply
Re:OC200 & EAP225 10mbps Max on Wifi
2022-09-13 15:09:23

  @GLyons 

 

For testing purposes, unplug all but 1 AP, and then disable 2.4G radios on that AP.  Please provide the output from a speed test at speedtest.net or your carrier's speed test site.

<< Paying it forward, one juicy problem at a time... >>
  2  
  2  
#2
Options
Re:OC200 & EAP225 10mbps Max on Wifi
2022-09-14 09:53:41

  @d0ugmac1 thanks for the suggestion, it has turned out to be a fault in the POE switch, (TL-SG1005P) we have swapped it out with another one and its working fine now.

 

  0  
  0  
#3
Options
Re:OC200 & EAP225 10mbps Max on Wifi
2022-09-14 16:09:14

  @GLyons 

 

FYI... be careful with the 'Extend' switch on the back of the 1005P unit... it hard limits the ports to 10Mbps.  Make sure it's OFF for normal use.

<< Paying it forward, one juicy problem at a time... >>
  0  
  0  
#4
Options