Business Community > Controllers > The VLAN of the wireless device is not displayed.
< Controllers

The VLAN of the wireless device is not displayed.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

The VLAN of the wireless device is not displayed.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
The VLAN of the wireless device is not displayed.
The VLAN of the wireless device is not displayed.
2022-08-26 07:07:55 - last edited 2022-09-06 06:24:55
Tags: #Highlighted Thread #vlan
Model: Omada Software Controller (Linux)  
Hardware Version: V1
Firmware Version: 5.5.6

Hello.

 

 

The device with IP 10.9.80.123 in the image above belongs to VLAN 80.
Assigned to VLAN 80 via PPSK with RADIUS and received IP.

Other wireless devices belong to VLAN 1.

However, VLANs are not displayed on the client tab.

Is there a way to mark it?

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:The VLAN of the wireless device is not displayed.-Solution
2022-09-06 06:15:55 - last edited 2022-09-06 06:24:55

Dear @jini, @Philbert,

 

The VLAN of the wireless device will be displayed after upgrading the EAP to the firmware adapted to Omada Controller v5.5.

Please wait patiently for the new EAP firmware. Cheers!

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  2  
  2  
#4
Options
3 Reply
Re:The VLAN of the wireless device is not displayed.
2022-08-28 15:13:05

  @jini 

 

Yeah i had noticed this before, never found a way to mark it..    It appears to work fine on LAN connected devices, just WLAN doesnt report.   

 

Not sure if this is a bug or feature, however like you i have .80.x  as VLAN 80    .90.x  as VLAN 90 etc so its not an issue  :)

  0  
  0  
#2
Options
Re:The VLAN of the wireless device is not displayed.
2022-08-29 06:26:27

  @Philbert 

Thank you reply.

 

That's right, there's no problem with the usage. It would be nice to see if it was just marked.

 

Can you display it check with the IP band set on the LAN?

  0  
  0  
#3
Options
Re:The VLAN of the wireless device is not displayed.-Solution
2022-09-06 06:15:55 - last edited 2022-09-06 06:24:55

Dear @jini, @Philbert,

 

The VLAN of the wireless device will be displayed after upgrading the EAP to the firmware adapted to Omada Controller v5.5.

Please wait patiently for the new EAP firmware. Cheers!

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  2  
  2  
#4
Options

Information

Helpful: 0

Views: 603

Replies: 3

Tags

Highlighted Thread
vlan
Related Articles
Fixed ip address VLAN on omada
2369 0
Blocked device
1559 0
VLAN and Firewall Rules
334 0
Cannot generate reports on Omada Software Controller 5.3.1
2379 0
Dynamic VLAN assignement with Radius authentication
1880 1
Failed to optimize device because of no scan result
710 0
About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.