This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
I'm searching everywhere web/cli, where is located the SFP optical link value in order to debug fiber issue?
regards
Armand
I'm using Omada Controller and TL-SG2210P, it also has two SFP ports and on controller UI, it just shows up like other Ethernet ports. So currently I did not connect anything to SFP port and it shows link down.
@Somnus Yes I have the same, but we need to have the optical output in dbm...
llike this:
This usefull to eliminate fibre issue...
It's not available on the controller or web interface. In old days there was a CLI command that can show all SFP status but I can't remember it was which command.
I think you can send this requirement to Request&Suggestions block.
Helpful: 0
Views: 946
Replies: 3
No one has voted for it yet.
We use cookies and browser activity to improve your experience, personalize content and ads, and analyze how our sites are used. For more details, please read our Privacy Policy.
