Creating DMZ LAN and assign it to a specific port (RJ45)
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi,
With most multi-port routers, I can assign a specific port as a DMZ which allows me to segregate the network and allows me to use additional switches.
Is it possible to configure the ER7206 router to do this using Omada application ?
if so, can you please provide steps.
Thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
DMZ functionality is created as a rule under Port Forwarding in the Omada controller.
Go to Setting > Transmission > NAT > Port Forwarding. Click + Create New Rule to load the following page and configure the parameters.
- Copy Link
- Report Inappropriate Content
@d0ugmac1 thanks.
However, my requirement is that the DMZ needs to be in a different subnet than my LAN.
This is why I was asking about assigning it to a different port.
Thanks
- Copy Link
- Report Inappropriate Content
It is not currently possible to apply a profile to a router's port in controller mode.
Hope this can help you:
The difference between Standalone mode and Controller mode of Business router
- Copy Link
- Report Inappropriate Content
@Fae Another example of the need to expand control/configurability of each of the routers LAN ports when under Omada Control.
In the meantime, TPLINK needs to do a better job of describing the limitations of Omada-controlled routers...ie 1 router/Site, limited port configs etc.
- Copy Link
- Report Inappropriate Content
@Fae Any updates on this request ? Is this something the SW team is going to implement ? Thanks
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1761
Replies: 5
Voters 0
No one has voted for it yet.