EAP225-outdoor showing as disconnected after oc200 updates to 5.3.1
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.EAP225-outdoor showing as disconnected after oc200 updates to 5.3.1
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
A few weeks ago I tried migrating to the software controller on Linux using 5.3.1 from my oc200 and I ran into this issue where my eap225-outdoor was showing as disconnected. I tried re-adopting it and it would work for a minute and then show as disconnected again. I thought it might have something to do with migrating between different versions of the controller, 5.1.7 to 5.3.1, so I reverted back to my oc200 and restored from backup and everything was fine.
So today I tried to update my oc200 to 5.3.1 and I ran into the same issue. My eap225-outdoor is showing as disconnected but reverting my oc200 to true previous firmware fixes the issue. Any ideas? it appears the issue is related to 5.3.1 as 5.1.7 worked fine on the software controller and the oc200.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
1. Revert to working controller
2. Default the problematic AP via controller i/f to device
3. Forget the AP from both OC200 and Linux controller instances
4. Adopt defaulted AP fresh into Linux controller.
No ladder climbing required.
- Copy Link
- Report Inappropriate Content
Dear @mackworth,
mackworth wrote
@Fae Any ideas before I get the ladder out and try and reset it? It shows as connected if I reboot it, but then the heartbeat gets missed and then goes to disconnected. Clients can still connect and the connection is good (I can stream video from my camera with no issues). It works correctly on controller 5.1.7.
Thank you for tag me here. I think I'll also suggest you try a reset for checking first. Since the EAP can be managed by the controller for a while, you don't have to get the ladder out to reset it, but just Forget the EAP225-Outdoor when it's shown as connected on the controller, then re-adopt it. If it still doesn't work, you may save a copy of the running log and backup file for further investigation.
Let me know if I can be of any further help then.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1310
Replies: 15
Voters 0
No one has voted for it yet.