Hi 

I am currently working on setting up a ER7206 load-balancer from a Omada server, and i am getting some strange behavior on one of the configure LAN ports. 

The overall setup is that there are 2 wan ports (WAN and WAN/LAN1) and 3 LAN ports (WAN/LAN2, LAN1 and LAN2) where LAN1 and LAN2 is configured to be in the same IP range (192.168.11.1/24) with enabled DHCP server . For the WAN/LAN2 port the IP range i set to be 192.168.10.1/24 with enabled DHCP server. The LAN1 and LAN2 is created as a default on by omada and the WAN/LAN2 i created with the "Create new LAN" 

On my laptop the ethernet port is on a docking station connected through USB. When i am using the WAN/LAN2 and the docking ethernet port my Windows Subsystem Linux terminal (WSL) is not getting a internet connection, i cant ping out on the internet, but i dont have any problems browsering the web nor problems pinging from a windows powershell terminal.

I also have a ethernet to USB adaptor, when using that with the WAN/LAN2 port my laptop is not getting a connection to the internet at all. The laptop gets an IP from the DHCP server as it should. 

When i switch over to use the LAN1 or LAN2 i dont have any problems connecting to the internet neither with the docking station nor the USB adaptor. 

Network - LAN - profile - All

I can see under the network - profile and the "all" profile that the "LAN10" which is the WAN/LAN2, is set under the Tagged Networks. Can this course my problem? if so, is there a way to fix it, because i cant edit in the "all" profile. 

There is created a profile for the LAN10, where Native Network is set to LAN10 and Untagged network to LAN10 

I will provide more information if needed, just ask :D

thanks in advance

Regards Andreas