Omada Setup with ExpressVPN Router
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I just installed an Omada setup in my house with the following hardware and connected in the following order.
WAN -> ER605 -> Switch -> EAPs -> Hardwired Connections
I have a Linksys WRT3200ACM router with VPN Express installed on it that I would also like to run in this setup. Can anyone help me in my configuration? I've tried connecting the setup in the following orders but each time the ER605 disconnects from the setup. The goal is to have most of the traffic on the home network run through this VPN to encrypt the traffic. ExpressVPN offers split tunneling which I would like to keep intact if possible. The ExpressVPN firmware has no means of turning off DHCP that I am able to find. Any help would be greatly appreciated, thanks.
Tried so far.
WAN -> ER605 -> WRT3200ACM (LAN Port) -> Switch
WAN -> ER605 -> WRT3200ACM (WAN Port) -> Switch
@Hartman9 If your goal is to have different subnets routing to through the WRT3200ACM or straight through the LAN. I would do it like this:
Create two VLANs/subnets on the WRT3200ACM. Connect one of them to the WAN port on the ER605 and the other to the WAN/LAN1 port. Both of them should be setup as WAN ports. Then use policy-based routing on the Omada side to decide which subnets go to the VPN or not.
