Omada Controller Software - LAG / LACP - Add Switch Settings for port-channel load-balance
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Greetings.
The Omada controller software has general LAG configuration but it lacks a way to set the port-channel load-balance algorithm of the LAG.
When the switches are in standalone mode this parameter is available in their web GUI:
(section 3.2.3, page 126)
as well as their CLI:
Jetstream Switch CLI Reference Guide
(chapter 13.2, page 104)
However when they are under the control of the Omada software they cannot be managed via their web GUI nor their CLI and this parameter does not appear in the Omada GUI so there doesn't appear to be a way to set/change it.
Could this setting be surfaced in the Omada Controller Software GUI?
Additionally, there are two other LACP commands available in standalone mode that aren't in the Omada GUI - system-priority and port-priority, it would be nice if these could be surfaced in the Omada GUI as well.
Thanks!
