This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.EAP615 in series
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello
I have 2 Eap615 and one is connected to the other that is connected to my SG3210 switch , i have the problem that wlans with vlan tags don't work on the second repeater they get no IP address , on the first repeater everything is working fine.
Strangely everything was working fine but after a power outage it is not working anymore i tried readopting the repeaters and restarting everything but nothing changes.
Thank you
Ramiro
@2ramiro If it is related to VLANs, you may check two following things:
1. On TL-SG3210 switch Ports settings, the downlink port ( connected to EAP615) should have profile All;
2. On Devices list, check the EAP615 Status and make sure it is Connected;
If the status is not Connected, try to reset the EAP and then adopt it again.
There's also the problem of limited VLAN options on the local ethernet ports of the wall units, and while I don't have a 615 (yet) my 235 certainly has this limitation. Specifically, they are either untagged, or can have a single tag. In theory, you could make a single SSID with VLAN work on the piggy-backing AP, but you will not have the same versatiity you do with the primary port of the primary AP which is connected directly to your Omada switch. The image below is from the Device->AP->Settings...
