OC200 controller went offline and has now been off for 24 hours
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.OC200 controller went offline and has now been off for 24 hours
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
My OC200 went on and offline continuously yesterday and then went offline and has not come back on for over 24 hours. What do I need to do to figure out why?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Seems obvious that you have a loss of comms between the Office and Control rooms, this would cause the symptoms you are seeing. I think there are 3 ways that this could happen, 1. power glitch in office 2. bad cable between rooms 3. bad power supply on either SG switch or the switch it's connected to downstream. I do not think this is a broadcast storm issue at this point, however, Occam's Razor may apply later.
If it were my network I would do two things: 1. move OC200 to Office and power it directly from a POE port on the SG2210P 2. run a continuous ping with stats from a computer connected in the Control room. My expectation would be that the AP, and Router would no longer report as down, but that you may notice lost packets between the ping computer and let's say the cable modem or ER605 Wan IP.
- Copy Link
- Report Inappropriate Content
I will let you know my Omada System setup so it may make more sense.
In my Office, is where my cable comes in for the cable modem. I have it attached to the ER605 and then run it into my Office switch. The office switch runs out to different places, but also runs out to my control room where I have 2 switches (a 16 port and 8 port PoE switch). These control room switches run to most of the stuff in my house including the OC200 which is located in the control room.
In the control room I replaced the cable to the OC200 and waited 5 minutes, but nothing happened. I then reset the control room PoE switch it was connected to and nothing happened. I reset the 16 port control room switch and the OC200 finally gave me both lights and came back online after a couple of minutes. I don't know if the issue is with the switch or something deeper??? I think it may be related to something in my office according to the alerts I had been getting. I will show you the alerts if anyone would care to comment.
|
Jun 05, 2022 10:16:27
am
|
|
|
|
Hallway EAP was disconnected.
|
Jun 05, 2022 10:16:27
am
|
|
|
ER605 Router was disconnected.
|
Jun 05, 2022 10:16:27
am
|
|
|
Hallway EAP was disconnected.
|
Jun 05, 2022 06:45:11
am
|
|
|
Office Switch was disconnected.
|
Jun 05, 2022 06:41:21
am
|
|
|
ER605 Router was disconnected.
|
Jun 05, 2022 06:41:21
am
|
|
|
Office Switch was disconnected.
|
Jun 05, 2022 06:20:01
am
|
|
|
ER605 Router was disconnected.
|
Jun 05, 2022 06:20:01
am
|
|
|
Hallway EAP was disconnected.
|
Jun 05, 2022 06:20:01
am
|
|
|
Hallway EAP was disconnected.
|
Jun 05, 2022 05:55:31
am
|
|
|
Office Switch was disconnected.
|
Jun 05, 2022 05:51:41
am
|
|
|
ER605 Router was disconnected.
|
Jun 05, 2022 05:37:11
am
|
|
|
Hallway EAP was disconnected.
|
Jun 05, 2022 05:37:11
am
|
|
|
Office Switch was disconnected.
|
Jun 05, 2022 05:37:01
am
|
|
|
Office Switch was disconnected.
|
Jun 05, 2022 05:03:41
am
|
|
|
ER605 Router was disconnected.
|
Jun 05, 2022 05:02:51
am
|
|
|
Hallway EAP was disconnected.
|
Jun 05, 2022 05:02:41
am
|
|
|
Office Switch was disconnected.
|
Jun 05, 2022 04:51:21
am
|
|
|
ER605 Router was disconnected.
|
Jun 05, 2022 04:51:11
am
|
|
|
Hallway EAP was disconnected.
|
Jun 05, 2022 04:51:01
am
|
|
|
Office Switch was disconnected.
|
Jun 05, 2022 04:33:31
am
|
|
|
ER605 Router was disconnected.
|
Jun 05, 2022 04:33:31
am
|
|
|
Hallway EAP was disconnected.
|
Jun 05, 2022 04:33:31
am
|
|
|
Office Switch was disconnected.
|
Jun 05, 2022 02:04:41
am
|
|
|
ER605 Router was disconnected.
|
Jun 05, 2022 02:01:41
am
|
|
|
Hallway EAP was disconnected.
|
Jun 05, 2022 02:01:41
am
|
|
|
Office Switch was disconnected.
|
Jun 05, 2022 02:01:41
am
|
|
|
Hallway EAP was disconnected.
|
Jun 05, 2022 01:48:31
am
|
|
|
Office Switch was disconnected.
|
Jun 05, 2022 12:54:21
am
|
|
|
ER605 Router was disconnected.
|
Jun 05, 2022 12:54:11
am
|
|
|
Hallway EAP was disconnected.
|
Jun 05, 2022 12:54:01
am
|
|
|
ER605 Router was disconnected.
|
Jun 05, 2022 12:40:51
am
|
|
|
Hallway EAP was disconnected.
|
Jun 05, 2022 12:40:31
am
|
|
|
Office Switch was disconnected.
|
Jun 05, 2022 12:32:21
am
|
|
|
ER605 Router was disconnected.
|
Jun 05, 2022 12:32:21
am
|
|
|
Hallway EAP was disconnected.
|
Jun 05, 2022 12:32:01
am
|
|
|
Office Switch was disconnected.
|
Jun 05, 2022 12:16:21
am
|
|
|
ER605 Router was disconnected.
|
Jun 05, 2022 12:16:21
am
|
|
|
Hallway EAP was disconnected.
|
Jun 05, 2022 12:16:11
am
|
|
|
ER605 Router was disconnected.
|
Jun 04, 2022 04:31:50
pm
|
|
|
Office Switch was disconnected.
|
Jun 04, 2022 04:31:41
pm
|
|
|
Hallway EAP was disconnected.
|
Jun 04, 2022 04:31:40
pm
|
|
|
Hallway EAP was disconnected.
|
Jun 04, 2022 03:59:31
pm
|
|
|
Office Switch was disconnected.
|
Jun 04, 2022 03:59:31
pm
|
|
|
ER605 Router was disconnected.
|
Jun 04, 2022 03:59:30
pm
|
|
|
Office Switch was disconnected.
|
Jun 04, 2022 03:37:00
pm
|
|
|
ER605 Router was disconnected.
|
Jun 04, 2022 03:37:00
pm
|
|
|
Hallway EAP was disconnected.
|
Jun 04, 2022 03:35:10
pm
|
|
|
Office Switch was disconnected.
|
Jun 04, 2022 01:45:21
pm
|
|
|
ER605 Router was disconnected.
|
Jun 04, 2022 01:45:21
pm
|
All of the alerts came from the office where the ER605 and Office switch is located. The Hallway EAP is on the Office Switch. Any ideas? Can I find out more info somehow? If so, where?
Thanks.
- Copy Link
- Report Inappropriate Content
Is it convenient to provide you with the hardware and software versions of these devices?
What is the hardware and software version of the controller?
Did this problem occur after changing any settings or upgrading the firmware version?
Are there any address reservations settings on the controller?
It would be better to check if there are any IP conflicts in the network?
- Copy Link
- Report Inappropriate Content
@Virgo I was down at the time, and couldn't find the info. Here it is.
Router - ER605 V2.0 - 2.0.1 Build 20220223 Rel.68551
Switch - TL-SG2210P v3.20 - 3.20.2 Build 20210806 Rel.55686
EAP - EAP245 v3.0 - 5.0.5 Build 20220216 Rel. 61848
OC200 - OC200 2.0 - Version 5.1.7 Firmware 2.1.2 Build 20220323 Rel.60697
There has been no settings changes for days. Nothing was changed, it just started happening.
All of the devices I have are are setup static. Many of my clients are static also, like my cameras, and several servers that need to be static, my printer, and my 2 NAS. I have 2 things set for reservations.
I have not seen any alerts or anything that say there may be an ip conflict. I guess I'm not sure where to look in that case.
- Copy Link
- Report Inappropriate Content
I had 4 new alerts this morning, 4 is good compared to 54 and totally going offline for 24 hours.
Looking at the content, it started with the Hallway EAP, then 9 seconds later, the office switch which is connected to the EAP, then 1 second later, the ER605 router disconnected. Then 2 minutes later the office switch shows disconnected again and that is it. Is there anything, anyplace that shows the reason for the disconnecting?
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@d0ugmac1 I'm sorry, ignorance here. Topology image?
- Copy Link
- Report Inappropriate Content
Yes, a network topology diagram can help to locate the problem more clearly.
You can show how all the devices are connected and what are the approximate IP addresses?
- Copy Link
- Report Inappropriate Content
@Virgo I don't know what I was thinking. I do know what topology is. I wasn't thinking I guess.
Anyway, I have looked at every item in the house that I have on the network. Every one of them is accounted for and all ip addressess are accounted for. None are conflicting. My issue seems to be coming from the first 3 links in the chain of the whole system.
The Hallway EAP disconnects, then the Router, then the switch. It has done this cycle twice this morning already.
- Copy Link
- Report Inappropriate Content
Seems obvious that you have a loss of comms between the Office and Control rooms, this would cause the symptoms you are seeing. I think there are 3 ways that this could happen, 1. power glitch in office 2. bad cable between rooms 3. bad power supply on either SG switch or the switch it's connected to downstream. I do not think this is a broadcast storm issue at this point, however, Occam's Razor may apply later.
If it were my network I would do two things: 1. move OC200 to Office and power it directly from a POE port on the SG2210P 2. run a continuous ping with stats from a computer connected in the Control room. My expectation would be that the AP, and Router would no longer report as down, but that you may notice lost packets between the ping computer and let's say the cable modem or ER605 Wan IP.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2520
Replies: 11
Voters 0
No one has voted for it yet.