lost config of mesh with omada controler

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

lost config of mesh with omada controler

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

dudu.orp

2022-05-16 21:02:01 - last edited 2022-05-17 00:52:39

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-05-16

lost config of mesh with omada controler

2022-05-16 21:02:01 - last edited 2022-05-17 00:52:39

Hello

I did configure a Mesh with 4 EAP Access points at home. The Omada Controler was installed on my computer. This computer crashed and was reset. I've lost all the config of the Mesh

When I install a new Omada controler, I can see 3 of the 4 AP, but I cannot "adopt" them.

the Log entry only say it failed

When I try to connect to the AP directly using the IP address, it is not reachable.

what do you suggest? Reset of all AP?

thank you

Vincent

1 Reply

terziyski

LV7

2022-05-16 22:30:41 - last edited 2022-05-17 00:52:39

Posts: 7113

Helpful: 5333

Solutions: 1207

Stories: 7

Registered: 2013-10-12

Re:lost config of mesh with omada controler

2022-05-16 22:30:41 - last edited 2022-05-17 00:52:39

@dudu.orp

Check this thread for a similar case.

If this was helpful click on the arrow pointing upward to make it blue. If this solves your issue, click the star to make it blue and mark the post as a "Recommended Solution".

lost config of mesh with omada controler

lost config of mesh with omada controler

Information

Voters 0

Tags